Stihl HSA 100.0 Manual De Instrucciones página 30

English
► Depress the locking lever and hold it in that
position.
► Press and hold the trigger.
► If the cutting blades run: Do not use your
hedge trimmer; contact your STIHL authorized
dealer.
The control bar is defective.
► Depress the control bar and hold it in that
position.
The cutting blades run.
► If 3 LEDs flash red: Remove the battery and
consult a STIHL dealer.
There is a malfunction in the hedge trimmer.
► Release the control bar.
The cutting blades stop running after about 1
second.
► If the cutting blades continue to run after 1
second: Remove the battery and contact your
STIHL authorized dealer.
The hedge trimmer is defective.
10.2 Testing the Battery
► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
11 Operating the Hedge Trim‐
mer
11.1 Holding and Controlling the
Hedge Trimmer
► Hold the hedge trimmer with one hand on the
control handle – wrap your thumb around the
control handle.
► Hold the hedge trimmer with the other hand on
the loop handle – wrap your thumb around the
loop handle.
11.2 Turning the Control Handle
The control handle can be set to three (3) posi‐
tions depending on the application.
30
11 Operating the Hedge Trimmer
1
► Pull out and hold the locking slide (1).
► Rotate the control handle (2) clockwise or
counterclockwise.
► Release the locking slide (1).
► Rotate the control handle (2) clockwise or
counterclockwise until the control handle (2)
snaps into place.
11.3 Cutting
► Use pruning shears or a chainsaw to cut out
thick branches first.
► Swing the hedge trimmer from the bottom
upwards in an arc while making the cut.
► Lower the nose of the hedge trimmer without
cutting.
► Walk forward slowly in a controlled manner.
► Swing the hedge trimmer from the bottom
upwards in an arc while making the cut.
► Cut the other side of the hedge in the same
way.
► Hold the cutting blades at an angle of 0° to 10°
to the top of the hedge.
► Swing the hedge trimmer horizontally and in
an arc while making the cut.
► If cutting performance deteriorates: Sharpen
the cutting blades.
For optimum performance, observe the recom‐
mended temperature ranges,
12 After Finishing Work
12.1 After Finishing Work
► Switch off the hedge trimmer and remove the
battery.
► If the hedge trimmer is wet: Allow the hedge
trimmer to dry.
2
0-10°
19.5.
0458-020-9801-A