SOMFY ilmo 40 WT Instructions página 27

These instructions apply to all ilmo 40 WT drives across all torque/speed ranges.
1. Prerequisite information
1. 1. Area of application
1. 2. Liability
2. Installation
2. 1. Installation
2. 2. Wiring
2. 3. Commissioning
2. 4. Tips and recommendations for installation 28
The ilmo 40 WT is a non-adjustable motor: a simple connection is all that is required.
The ilmo 40 WT programs its end limits automatically.
The ilmo 40 WT can be mounted either on the right or the left. It can be controlled from a control point
with a fixed position or momentary action-type switch.
The ilmo 40 WT is equipped with:
obstacle protection to protect the roller shutter when it is being lowered.
-
anti-freeze protection to protect the roller shutter when it is being raised.
-
1. PrereqUIsITe InformaTIon
1. 1. area of aPPlICaTIon
The ilmo 40 drive is designed to drive all types of roller shutters equipped with rigid links and stops,
which fulfil at least one of the following conditions:
The motorised product is controlled by a switch without a locking device (see the attached
-
instructions
document).
When deployed, all parts of the motorised product are more than 2.50 m above ground or any
-
other permanent access level.
The apron of the roller shutter can be raised by 4 cm if a force of 150 N is applied upwards on the
-
final slat placed 16 cm from its fully-deployed position.
If the roller shutter has slats which can open, the openings must not allow a pin of diameter 5 mm
to pass through.
1. 2. lIabIlITy
Please read these instructions carefully before installing and using the ilmo 40 drive. In addition
to following the instructions given in this guide, the instructions detailed in the attached Safety
instructions document must also be observed.
The ilmo 40 WT drive must be installed by a motorisation and home automation
professional, according to instructions from somfy and the regulations applicable in
the country in which it is commissioned.
It is prohibited to use the ilmo 40 WT drive outside the field of application described above. Such
use, and any failure to comply with the instructions given in this guide and in the attached
instructions
document, absolves Somfy of any liability and invalidates the warranty.
The installer must inform its customers of the operating and maintenance conditions for the ilmo 40
WT drive and must provide them with the instructions for use and maintenance, and the attached
Safety instructions
operation on the ilmo 40 WT drive must be performed by a motorisation and home automation
professional.
If in doubt when installing the ilmo 40 WT drive, or to obtain additional information, contact a Somfy
adviser or go to the website www.somfy.com.
Safety warning!
Copyright © 2009- 2014 Somfy SAS. All rights reserved.
5061937C003_ilmo_40_WT.indb 25
ORIGINAL GUIDE
ConTenTs
25
25
25
26
26
27
28
document, after installing the ilmo 40 WT drive. Any After-Sales Service

3. Use and maintenance
3. 1. Raising and lowering the roller shutter
3. 2. Obstacle detection
3. 3. Anti-freeze protection
4. Tips and recommendations for use
5. Technical data
Caution!
Images not contractually binding
EN
29
29
29
29
30
30
Safety
Safety
Information
25
24/10/2014 10:21