VOSS.farming FM20 WiFi Instrucciones De Operación página 36

g
- Indicates the last data transmission
• A bar display is located below each device. It shows
the time since the last information was sent. The
transmission interval between the energiser and the
Fence Manager is one minute. The transmission interval
between the Fence Sensor and the Fence Manager is
15 minutes.
• The bar is displayed if radio contact is lost for more
than two minutes.
• An alarm is triggered once the bar underlines the full
width of the device display. The bar is reset if data has
been transmitted in the meantime.
6.5 DETAIL WINDOW - ENERGISER
h - Name and MAC address of the
energiser
I n fo
The name of the device (above)
can be changed by the user.
i - Status and power level of the energiser
• See point c in Section 6.4.
j - Signal strength between the Fence
Manager and the energiser
k - Fence voltage value [kV]
l - Power of the energiser relative to
the load on the fence system
I n fo
The information shown here is
only possible for VOSS.farming
XTREME duo RF energisers.
m - Defined voltage limit value for triggering the alarm [kV]
n - Battery status of the energiser when connected [V]
o - Time since last data transmission
p - Current load on the fence system in ohms and graphic representation
I n fo
»
The information shown here is only possible for VOSS.farming XTREME duo RF energisers.
»
The lower the value, the higher the load on the fence system.
q - Fence Manager WiFi connection status
online -
•
• conn� WiFi -
I n fo
The WiFi connection must be configured to connect with the cloud application (website/
app). A WiFi connection is not necessary to establish a connection between the energiser
and Fence Manager FM20.
36
INSTRUCTION MANUAL VOSS.FARMING FENCE MANAGER FM20 WIFI
Fence Manager is connected to WiFi
Fence Manager is not connected to WiFi
2 min.
Failure at G1
5 min.
20 min.
Failure at G2
60 min.
Failure at G3 (Alarm is triggered)
41660 - 11.2022 - V2