Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1.
Remove the cooking grate, burner cover and flame spreader, and place the product upside down on
a padded mat.
2. Make sure that the ignition equipment and flame control equipment are not affected in this opera-
tion.
3. Stick the sponge on the edge around the bottom perimeter of the product. Do not leave gaps that
have not been sealed with the sponge along the entire perimeter.
Never seal the plate to the recess with silicone
Sealing the hob with silicone is not recommended, as if the
hob has to be removed, it will be very difficult to remove it
from the worktop and may even break the glass.
Infiniton is not responsible for any damage caused by
applying silicone, which would void the warranty.
(A) SEALING STRAP
(C) SCREW
Gas connection
This appliance must be installed and connected in accordance with the specific regulations of the
country where it is to be installed.
(B) SUPPORT
Gas supply and installation guidelines
LPG > NG
Seal
Gas rail
G1/2"Female coupler
.
1.
Position the bracket (B) by aligning it over the
screw holes. There is a set of screw holes for
each corner of the plate (H). Slightly tighten the
screw (C) towards the bracket (B), so that the
bracket locks onto the hob and you can adjust
the position.
2. Carefully rotate the hotplate and then gently
insert it into the recess you have cut out.
3. On the underside of the hob, adjust the brac-
kets to the appropriate position on the hob.
Then tighten the screws (C) to ensure that it is
secured in position.
NG > LPG
Seal
Gas rail
Ø11.5 Female coupler
33
English
infiniton.es
Publicidad
