Note: To select a stored PSET or manual target torque or angle mode, repeatedly press ENTER
button until desired PSET or manual mode is displayed.
Editing a Preset
Edit PSET function gives user ability to edit stored PSETS on wrench.
1. From Preset screen to be edited, press and hold UNITS
2. CHANGE PRESET screen is displayed.
3. Highlight
EDIT
selection using UP
4. MINIMUM TORQUE or ANGLE screen is displayed. Value can be changed by pressing
UP
/DOWN
ENTER
button.
5. MAXIMUM TORQUE or ANGLE screen is displayed next. Value can be changed by pressing
UP
/DOWN
ENTER
button.
6. BATCH COUNT screen is displayed next. Value can be changed by pressing UP
buttons. Once desired batch count value has been set, press ENTER
7. PSET target screen is displayed labeled with same PSET number.
PSET 02
1of4
90°
Preset Angle Screen
PSET 02
1of4
92°
Preset Angle Screen
Note: Pressing ENTER
PSET.
buttons. Once desired target torque or angle value has been set, press
buttons. Once desired target torque or angle value has been set, press
UNIT
CHANGE PRESET
button
DELETE
held
EDIT
EXIT
UP/DOWN buttons
CHANGE PRESET
DELETE
EDIT
EXIT
ENTER button
button while
U
/DOWN
buttons then press ENTER
ENTER
button
MINIMUM ANGLE
92°
EXIT
menu selection is highlighted will exit without editing
11
button for 3 seconds.
button.
UP/DOWN buttons
ENTER
MAXIMUM ANGLE
button
94°
BATCH COUNT
0
button.
/DOWN
UP/DOWN buttons
ENTER
button
UP/DOWN buttons