Publicidad
Idiomas disponibles
Idiomas disponibles
MODE SETUP
CALIBRATION
SET DATE/TIME
SET CAL INTRVAL
ENTER
button
Note: Clock Date and Time must be set before calibration interval will function. If batteries
are removed from wrench for longer than 20 minutes, clock will revert to default settings
and must be re-entered at power on.
Note: Calibration interval is calculated from either In-Service Date or last Calibration date
(see SHOW INFO menu) depending on which is more recent date. When clock Date is
greater than In-Service or Last Calibration date, plus Cal Interval, "CAL NEEDED"
message will be displayed on power up and after a re-zero. Pressing ENTER
will continue to target menu. Applying torque while "CAL NEEDED" message is
displayed will immediately display torque or angle measurement and return to target
menu when released.
Note: As an alternative to calibration interval, a Calibration Cycle Counter is provided in
Calibration menu (Contact your local Williams Repair Center regarding Calibration
menu).
CAL INTRVAL
ENTER
button
DISABLED
EXIT
UP/DOWN buttons
CAL INTRVAL
12 MON
EXIT
22
button
Publicidad
