Williams MULTITORQ2 Manual De Instrucciones página 7

6. Pressing ENTER
default, "OFFSET IN USE" message will be displayed on target screen.
00
100.0
FT-LB
M
Target Screen
00
OFFSET IN USE
100.0
FT-LB
M
Note: Head length entered is offset length measured from center of drive to center of fastener.
������������
Use of Negative Offsets
Note: Enter a negative value for offset when used in reverse direction.
When length of an offset is negative, maximum fastener target is limited by following formulas:
100 ft-lb wrench:
Maximum Target Torque =
offset * 8 + 100
Offset Max Target
-1" 92 ft-lb
-2" 84 ft-lb
-3" 76 ft-lb
-4" 68 ft-lb

button after length is set returns to main menu. If length is changed from

ENTER
EXIT
button
LANGUAGE
held
SET HEAD LENGTH
SHOW DATA
M
UP/DOWN buttons
EXIT
LANGUAGE
SET HEAD LENGTH
SHOW DATA
M
ENTER button (after length change)
������������
250 ft-lb wrench:
Maximum Target Torque =
offset * 12 + 250
Offset
-1"
-2"
-3"
-4"
ENTER
SET HEAD LENGTH
button
0.000
M
M
UP/DOWN buttons
Max Target
238 ft-lb
226 ft-lb
214 ft-lb
202 ft-lb
7
UNITS
button
SET HEAD LENGTH
0.0
IN
M
M
UP/DOWN buttons
600 ft-lb wrench:
Maximum Target Torque =
offset * 14 + 600
Offset Max Target
-1" 586 ft-lb
-2" 572 ft-lb
-3" 558 ft-lb
-4" 544 ft-lb
MM