Publicidad
Idiomas disponibles
Idiomas disponibles
CAL: Date of last wrench calibration.
ISD: In-Service Date.
TCF: Torque Calibration Factor.
ACF: Angle Calibration Factor.
VER: Software version.
OVR CNT: Overtorque Counter tracks how many times an over-torque event occurred on
wrench (torque >125% of full scale).
TQZ: Torque Zero Offset.
ANZ: Angle Zero Offset.
4. Pressing ENTER
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
Setting Sleep Time
This function will allow user to set interval wrench enters power-down state following last applied
torque or button press.
1. From Settings menu, use UP
ENTER
button.
2. SLEEP TIME screen is displayed.
3. Use UP
/DOWN
Selectable Intervals:
2 MIN (factory default)
5 MIN
10 MIN
30 MIN
1 HR
2 HR
8 HR
4. Press ENTER
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
UP/DOWN buttons
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
ENTER
button
button exits Show Info screen and returns to Settings menu.
ENTER
CAL: 2014/01/01
button
ISD: 2014/01/01
TCF:
14800
ACF:
1257
UP/DOWN buttons
VER: 1.4.0
OVR CNT: 0
TQZ:
-1539
ANZ:
ENTER
button
/DOWN
buttons to select sleep interval.
button to accept selection and exit to Settings menu.
SLEEP TIME
ENTER
button
2 MIN
EXIT
UP/DOWN buttons
SLEEP TIME
8 HR
EXIT
8196
buttons to highlight
14
SLEEP TIME
selection then press
Publicidad
