Publicidad
Idiomas disponibles
Idiomas disponibles
User Instructions
Basic Functions (Quick Start)
BATTERY
PROGRESS
CONDITION
Wrench Power On Sequence
Note: Do not turn on wrench while torque is applied, otherwise torque zero offset will be incorrect and
wrench will indicate a torque reading when torque is released. If this occurs, re-zero wrench by
momentarily pressing POWER button while wrench is on a stable surface with no torque applied.
1. Turn On Wrench.
Momentarily press POWER
screen. If previous measurement was angle measurement, then angle re-zeroing screen follows
the torque zeroing screen. After re-zeroing, the target torque or target angle screen is displayed
depending on previous measurement mode.
2. Select Measurement Mode.
Toggle between target TORQUE and ANGLE screens by repeatedly pressing ENTER button.
Figure 1
TORQUE AND/OR
ANGLE DISPLAY
MODE
LIGHTS
COUNT
DATA
STORAGE
PROGRESS
ALERT
LIGHTS
Install fresh "AA" cell into handle of wrench.
button. Williams logo is displayed followed by torque re-zeroing
TORQUE ZEROING
250.0
Target Torque Screen
ENTER
ANGLE ZERO REQ
button
ON/OFF AND
INCREMENT
RE-ZERO
BUTTON
BUTTON
UNITS AND
DECREMENT
PRESET ENTRY
BUTTON
BUTTON
00
ENTER
button
FT-LB
ENTER
button
4
PROGRESS LIGHTS
Yellow - First light indicates 40% of target
torque or angle reached. Second
indicates 60% of target reached.
Third indicates 80% of target
reached.
Green - Indicates target torque or angle
reached.
Red
- Indicates exceeded torque or
angle target plus 4% or exceeded
maximum Preset target.
MODE SELECT AND MENU ENTRY BUTTON
AUDIBLE
ALERT
LCD BACKLIGHT
WRENCH
LOCKED
AND
ALERT
PEAK TORQUE/ANGLE
RECALL BUTTON
ANGLE ZEROING
--
SET STILL
00
180°
Target Angle Screen
Publicidad
