Pro-Logix PL2110 Manual Del Usuario página 7

K
Simple Touch Button
TM
Allows quick and easy set-up for each specific charging
routine.
4-Stage Charging Process
The charger uses a proprietary 4-Stage charging process
designed to optimally charge and maintain batteries. The
charging process includes a soft start mode to properly
charge deeply discharged batteries and is beneficial for
the long-term health of your batteries. The final stage in
the charging routine is a Maintenance Mode that allows
the charger to be connected indefinitely to a battery and
maintain a proper charge level.
Multiple Battery Compatibility
The charger will properly charge a wide variety of battery
types, including Conventional, Maintenance Free,
AGM, Gel Cell and Deep Cycle batteries.
Multiple Output Options
The charger comes complete with both DC output clips
and ring terminals to allow a greater range of use and
improved convenience. Purchase additional ring terminals
for each of your vehicles to speed charging set-up time
and reduce hassle.
L
CAUTION – Make sure charger is unplugged from
electrical outlet before performing any maintenance.
A minimum amount of care can keep your battery charger
working and looking good for years.
1. Clean the clamps after each use. Wipe off any battery
fluid that may have come in contact with the clamps to
prevent corrosion. Battery fluid may be neutralized
with a solution of water and baking soda.
PRO-LOGIX BATTERY MAINTAINER FEATURES
Control Panel
CHARGER CARE & MAINTENANCE
Smart Clamp Technology
The charger will send power to the output leads only when
a proper battery connection is made.
Reverse Polarity Protection
Guards against reverse connections. Warning LED will
light on control panel, the unit will emit an audible alarm
and power will not be sent to output cables if a reverse
connection is sensed.
Battery Fault Protection
Guards against shorted or otherwise compromised
batteries. Conditions that cause the fault condition include
connecting to a battery with a voltage less the 3V,
connecting to a battery with a voltage above 15V in 12V
mode (7.5V in 6V mode), connecting to a battery with a
shorted cell or a short circuited battery or if the charger
diagnoses an incorrect voltage selection.
Fully Enclosed Design
The charger utilizes a fully enclosed, IP65-compliant
design, preventing dirt, dust and grime from entering the
interior of the charger.
2. If needed, the case may be wiped clean with a soft
cloth.
There are no user-serviceable parts inside.
For information concerning use, applications, or service,
call Technical Service at (800) 328-2921.