cecotec Cumbia POWER EXPRESSO Manual De Instrucciones página 20

ENGLISH
3. OPERATION
Coffee filter filling
- Insert the desired filter in the portafilter.
- Fill the filter with natural ground coffee.
- Make sure that the amount of coffee inserted does not exceed the edge of the filter.
- Use the measuring spoon to press the coffee, add more coffee if necessary and press it
again.
- Clean any coffee that exceeds the edge of the filter in order to install the portafilter
correctly on the unit and to ensure proper operation. Fig 2
Warning
It is very important to press the coffee well in order to obtain good results.
Portafilter installation
- Place the portafilter in position, its handle must match the UNLOCK mark. Turn the
portafilter counterclockwise to lock it until its handle matches the LOCK mark. Fig 3
- To remove the portafilter from the brewer, follow these steps in reverse order.
Warning
The device will automatically enter standby mode after 15 minutes of no operation. If the
device goes into standby mode, it is recommended to turn the On/Off switch to the off position.
Coffee brewing
Warning
It is recommended to use bottled water for better maintenance of the coffee machine.
1. Follow the instructions in the coffee filter filling section to fill the filter (for 1 or 2 coffees).
2. Follow the instructions in the installation section of the portafilter to install it.
3. Slide the coffee switch downwards, the coffee will start dispensing. Once you have
obtained enough coffee, turn the switch to the off position.
Preparation of types of lattes
Once you have prepared the coffee, prepare the milk:
1. Slide the steam switch down, the blue indicator light will start flashing slowly.
2. Once it has warmed up, the blue light will stop flashing and remain steady.
3. Fill a cup or container with milk. It is recommended to use whole milk at room temperature
for best results.
38
POWER EXPRESSO 20 TRADIZIONALE/ LIGHT BLUE/ LIGHT GREEN/ LIGHT YELLOW/ LIGHT BEIGE
Warning
- Do not use warm or hot milk with the steam function.
- It is recommended to use a bowl or milk container with a minimum diameter of 70 ± 5
mm. Remember that the milk will double in volume. For this reason, make sure that the
container used for the milk is high enough.
4. Insert the steam tube into the milk container to a depth of 1-2 cm. When frothing the milk,
move the container up and down. Slowly turn the steam selector counterclockwise so
that the device generates steam. Fig 4
Warning
Turn the steam selector slowly. By turning it sharply, the accumulated steam may escape
under pressure and cause the milk to splash out, causing burns.
Note
The steam tube may emit a small amount of water before emitting steam.
5. Once you have the desired milk froth, turn the steam selector clockwise to the 0 position.
Warning
Wait at least 2 minutes after using the steam function before using it again.
6. Pour the milk or frothed milk into the glass with the previously prepared coffee, add sugar
to taste and sprinkle with cocoa powder if you wish to have a cappuccino. You can also
sprinkle cinnamon or cardamom powder.
Warning
Disassemble and clean the steam tube after each use. It is advisable to do a second steam or
hot water run over an empty glass to clean the internal passages of the steam tube.
Hot water
1. Place a glass or cup under the steam tube.
2. With the coffee and steam switches in the OFF position, turn the steam selector
counterclockwise, the machine will start dispensing hot water.
3. Once you have obtained the desired amount of water, turn the steam selector clockwise
to position 0.
- Let the machine warm up and repeat these steps to dispense hot water as many times as
necessary.
Device cooling process
- After steaming or brewing coffee, the temperature of the device is likely to increase
POWER EXPRESSO 20 TRADIZIONALE/ LIGHT BLUE/ LIGHT GREEN/ LIGHT YELLOW/ LIGHT BEIGE
ENGLISH
39