Publicidad
Idiomas disponibles
Idiomas disponibles
EN
7. Fill the draught can with acid
To-correct-the-pH-value-in-the-system,-use-acid-from-the-special-can-supplied.
The-can-is-empty-when-delivered.
Loosen- the- cap,- to- which- the- draught- element- is- attached- and,- using- a- funnel,- insert- 2- kg- pH- minus-
into-the-can.-Fill-with-water-up-to-a-level-around-the-maximum-mark,-taking-care-not-to-fill-too-much-and-
cause-the-liquid-to-spill-out.-Reinsert-the-draught-element-and-cap.-Close-the-cap-without-tightening-it-
excessively.
The-system-will-collect-the-required-amount-of-acid-to-keep-the-pH-levels-in-the-pool-under-control.
If the alarm for a lack of acid should switch on on the control panel, take care to refill the can
following the steps listed here above.
8. Start the electrolysis system with pH / ORP
control
Press-the-"AUTO"-key-to-start-the-system.
The- system- will- start- up- automatically- with- the-
default-settings.
SETTING THE ELECTROLYSIS SYSTEM TO STANDBY MODE
Press- the- "STOP"- key- on- the- control- panel- of-
the-electrolysis-system-with-integrated-pH-/-ORP-
control.
This-operation-is-necessary-every-time-people-use-
the- pool,- when- maintenance- must- be- performed-
on- the- probes- and- electrodes- or- when- sand- is-
being-completely-dissolved-in-the-water.
PLEASE NOTE: The disinfection system must be off while users are bathing.
18
pH
Electrolysis
ORP mV
7.0 ... 7.8 pH
Setpoint
Control Mode
Setpoint
AUTO
SET
MAN
CAL
STOP
pH CONTROLLER
ON
ALARM
pH
Electrolysis
ORP mV
7.0 ... 7.8 pH
Setpoint
Control Mode
Setpoint
AUTO
SET
MAN
CAL
STOP
pH CONTROLLER
ON
ALARM
pH
Electrolysis
7.0
-----
7.2
STOP
Setpoint
Control Mode
WATER-TREATMENT-KIT
650...800 mV
SET
CAL
ORP CONTROLLER
650...800 mV
SET
CAL
ORP CONTROLLER
ORP mV
690
700
Setpoint
Publicidad
