Makita DLS714 Manual De Instrucciones página 24

In the case of left bevel cut
(a) (b)
1. Inside corner 2. Outside corner
Table (A)
– Molding Bevel angle
position
52/38°
in the
type
figure
For (a) Left
inside 33.9°
corner
(b)
For (c)
outside
(d)
corner
Table (B)
– Molding
position in
the figure
For inside (a)
corner
(b)
For outside (c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the LEFT side of the blade after the cut has been
made.
(c) (d)
1 2
Miter angle
45° type 52/38°
type
Left 30° Right
31.6°
Left
31.6°
Right
31.6°
Molding Finished
edge against piece
guide fence
Ceiling Finished
contact edge piece will be
should be on the Left
against guide side of blade.
fence.
Wall contact
edge should
Finished
be against
piece will be
guide fence.
on the Right
Ceiling side of blade.
contact edge
should be
against guide
fence.
Cutting aluminum extrusion
► Fig.51: 1. Vise 2. Spacer block 3. Guide fence
When securing aluminum extrusions, use spacer blocks
or pieces of scrap as shown in the figure to prevent
deformation of the aluminum. Use a cutting lubricant
when cutting the aluminum extrusion to prevent build-up
of the aluminum material on the blade.
CAUTION:
aluminum extrusions. Thick aluminum extrusions
may come loose during operation and round alumi-
num extrusions cannot be secured firmly with this
tool.
Wood facing
WARNING:
facing to the guide fence. The screws should be
installed so that the screw heads are below the
45° type
surface of the wood facing so that they will not
interfere with the positioning of the material being
cut. Misalignment of the material being cut can case
Right
35.3°
unexpected movement during the cutting operation
which may result in a loss of control and serious
Left
personal injury.
35.3°
Right
CAUTION:
35.3°
thickness as the wood facing.
Use of wood facing helps to assure splinter-free cuts
in workpieces. Attach a wood facing to the guide fence
using the holes in the guide fence.
See the figure concerning the dimensions for a sug-
gested wood facing.
15mm (5/8")
35mm
(1-3/8")
1
1. Holes
NOTICE:
not turn the turn base with the handle lowered.
The blade and/or the wood facing will be damaged.
24 ENGLISH
4. Aluminum extrusion 5. Spacer block
Never attempt to cut thick or round
Use screws to attach the wood
Use the straight wood of even
420mm (16-1/2")
92mm 100mm 70mm 85mm
(3-5/8") (3-15/16") (2-3/4")
(3-3/8")
When the wood facing is attached, do
50mm-60mm
(2"-2-3/8")
27mm (1-1/16")
1