Tennant T300e Manual Del Operario página 10

English
EN
INSTALLING BRUSH/PAD
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine and remove
key.
1. Step down on the scrub head lift pedal to raise the
scrub head off the floor (Figure 6).
2. Attach the pad to the pad driver before installing
the disk (Figure 7). Secure pad with center- lock.
FOR SAFETY: Do not operate machine with pads
or accessories not supplied or approved by
Tennant. The use of other pads may impair safety.
3. Position the three lugs into the motor hub slots and
give the pad driver/brush a quick counter-clockwise
turn to engage hub (Figure 8). View through the
scrub head window to align lugs.
4. To remove the pad driver/brush, grip the disk and
give it a quick turn in the opposite direction.
10
FIG. 6
FIG. 7
FIG. 8
FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine and remove
key.
Remove the solution tank lid and fill the solution tank.
Stop filling tank when the level reaches the "3/3" mark
on the solution tank drain hose indicator (Figure 9).
Fill solution tank with water (not to exceed
60°C/140°F). Pour a recommended cleaning detergent
into the solution tank according to mixing instructions
on the container.
WARNING: Flammable materials can cause an
explosion or fire. Do not use flammable materials
in tank(s).
ATTENTION: Only use commercially approved
cleaning detergents. Machine damage due to improper
detergent usage will void the manufacturer's warranty.
The solution tank fill- port is equipped with two hose
clips to hold hose while filling. The two clips are
different hose diameter sizes (Figure 10).
FIG. 9
FIG. 10
Tennant T300e (07- 2022)