Publicidad
Speed Control
• The tool can run in different speeds. These are selected by
adjusting the speed selector found in the tool rear side (F).
• The specified number of passes depends on the material
and working conditions, it is advisable to determine it by
testing. It is advisable to reduce the number of passes
when applying the saw blade in operation against the
workpiece, as well as when cutting
plastic and aluminum.
• When working for a long time with a
WARNING
reduced number of passes, the electric tool may heat up
strongly.
Remove the saw blade and let the electric tool work for
approximately 3 minutes at maximum revolutions to cool
down.
Speed guide
Application
Shap curves
Curve cutting
Curve cutting
Standard cutting, fast cutting
Cutting Angle Adjust
To make bevel cuts adjust the cutting angle in the base
plate.
• Release the angle blocking lever (A).
• Once the adjustment lever is free, push the baseplate to
the front to release the locking system and turn it to the
desired angle, matching the guide with the graduated
marks (0°, 15°, 30°, 45°) (B).
• When making cuts with non-established angles use a
protractor or a graded circle.
• Secure the base plate into the desired angle tightening
strongly the blocking angle. The marks in the angles in the
base plate are accurate for most of the needs, but
checking the angle with a protractor and making a trial cut
on a piece of scrap wood is recommended.
8
ENGLISH
Speed
MIN-1
2 - 3
4 - 5
MAX
Preparation
F
A
A
B
Publicidad
