Publicidad
Start up
Balancing Action Control
The balancing action varies the saw glade cutting angle to increase the cut efficiency. This can also be adjusted while no-load
operation. To see more details, see the balancing action selection table. Do not use excessive force on the saw blade when
cutting with balancing action. The saw blade only cuts when going upwards.
Material
Hard
Straight and
Cut
curved
Additional Tips
• If the tool is overheated in excess, especially when
working in low speeds, set speed to the maximum and let
it run with no load during 2 or 3 minutes to cool down the
motor.
• Avoid prolonged use in low speeds.
• For an easier begin cutting in low speed at the beginning
of the cut and then increase to the right speed.
Cutting laminated materials
Use a blade with fine teeth when cutting most of laminated
materials or thin wood. To reduce splintering in the edges
fasten scrap wood pieces on both faces of the work piece
and make the cut.
CAUTION
Do not use the balancing action when
cutting closed circles or angles.
Tilt cut
Tilt cut can only be made onto soft
materials like wood, aerated concrete,
gypsum sheets, etc. Use only short
blades. Set the front edge of the base
plate onto the work piece and start the
tool. Press firmly against the work piece
and gently tilt the blade onto the piece.
Continue cutting through the cutting line.
Soft
Straight only
Balancing
Action
Control
• The saw blade cuts when traveling upwards and can chip
the upper side of the work piece. Use care the upper
surface is not visible when finishing the job.
• Occasionally, sparks can be observed though the
ventilation slots. It is normal and does not damage the
tool.
Cutting metal
Use a blade with fine teeth to work on iron materials and a
rough blade to work with non-iron materials. When cutting
thin metal sheets fasten some wood on both sides of the
sheet to reduce vibration or to prevent tearing the metal.
Both wood and metal shall be cut. Do not force the blade
when cutting thin metal or steel thin sheets. These are
harder materials and the cut takes longer. Excessive force
on the blade may reduce its useful life or damage the
motor. To reduce heat when cutting metal, add some
lubricant on the cutting line.
Work
piece
Scrap
wood
9
ENGLISH
Publicidad
