Sabiana WM-UH-ECM Instrucciones De Uso página 24

English
» Configuration Dip setting
Dip
1
2
Temperature control with Fan
3
Simultaneous ventilation with valves
4
D0-D0 water pump/boiler/Chiller
5
6
7
8
9
10
IMPORTANT NOTE!: The unit heaters in the Janus-ECM/UC-ECM range can be used in both heating
and cooling mode.
Dip1 allows to activate, or not, both modes that can then be selected through the T-MB control.
By setting the Janus-ECM/UC-ECM application, in cooling mode only, the control defines the fan speed
range by limiting its maximum speed, so as to reduce the air speed crossing the exchange coil prevent-
ing the detachment of the condensate drops generated during summer operation.
The output signal from the board, in summer mode, is therefore limited to
Position = On
Janus-ECM/UC-ECM
T3 enabled
management
CA = remote summer/winter
CF = night mode
/
/
/
Atlas-ECM/UH-ECM
Temperature control with valves
Continuous ventilation
D0-D0 machine status
CA = remote On / Off
CF = anti-freeze mode
24
Position = OFF
T3 disabled
/
/
/
4 V maximum speed
( ).