Publicidad
Idiomas disponibles
Idiomas disponibles
The batteries are highly explosive, keep them away
from sparks, flames, cigarettes and sources of
ignition and charge in a ventilated area.
Do not start the vehicle while the battery cables are
connected and the generator is running, otherwise
you may damage the vehicle and the generator.
The earth terminal (35) is connected to the command-and-
control panel (6), the non-current carrying metal parts and
the earth terminals of each socket.
To prevent electric shock to the user, damage to the
generator and the appliances connected to it, connect the
earth terminal to the ground. To do this, use a wire with
adequate capacity, as indicated below.
0.12 mm → 1 A
For example: for 20 A, a 2.4 mm wire.
Earth terminal
1. Ensure that the AC socket circuit breakers (29, 30) are in
the "OFF" position when starting the engine;
2. Open the engine access door (11);
3. Set the throttle lever (19) to the running position, to the
right;
4. Pull the decompression lever (26) while turning the
switch key (24) to the "START" position;
5. Release the decompression lever to start the engine and
then the key.
Operating the starter more than necessary may
discharge the battery more quickly or damage the
engine. Always leave the starter key in the "ON" position
during engine operation.
Earth wire
Earth rod or discharge
point
ON
1.
OFF
4.
5.
1. Switch off all appliances;
2. Remove the power cords of the appliances from the AC
sockets (31, 32, 33) and turn the circuit breakers of the
AC sockets (29, 30) to the "OFF" position;
3. Disconnect the cables connected to the DC terminals
(36, 37);
4. Let the engine run for 1 minute at no load;
5. Turn the ignition key (24) to the "OFF" position;
6. If the engine continues to run after turning the ignition
key to "OFF" position, press the engine stop lever (20).
Do not stop the engine using the decompression lever
or if there are connected appliances to the generator.
Stop it only after unplugging all devices.
5.
.
In the event of an emergency, immediately turn the
starter key (24) to the "OFF" position, and if the engine
continues to run, press the engine stop lever (20).
3.
6.
.
Engine stop lever
Publicidad
