Publicidad
1
3
B
1
5
B
30
1
4
B
Mounting the TV set (Xelos A42) on the
FLOOR STAND 5 MU
Mount the carrier horn
Mount the carrier horn "B" (sketch 3 / 4 / 5, reference line B)
on the FLOOR STAND 5 MU only with the previously removed
screws (carrier horn fastened to the table leg).
Make sure that the clamping screws in the carrier horn are on
the back of the TV set later.
Tighten the screws with a torque of approx. 5 Nm.
Replace the TV set in the carrier horn.
Clamp the TV set tight with the clamping screws in the carrier
horn, torque approx. 1 Nm.
If your carrier horn does not yet have the fastening holes for the
FLOOR STAND 5 MU, please contact our after-sales service.
The holes in the carrier horn (sketch 3 to 5) are slightly bigger
than the diameter of the screws. Therefore the TV set can still be
turned slightly even after the screws have not been tightened.
This enables you to turn the TV set to line up with the SOUND
PROJECTOR.
Tighten the screws with a torque of approx. 5 Nm.
The TV set and the FLOOR STAND 5 MU are now connected
mechanically.
You will fi nd instructions for connecting the cables or service
addresses in the operating manual of the TV set.
Publicidad
