Publicidad
Idiomas disponibles
Idiomas disponibles
Overheat protection
When the power tool works under heavy load and the battery heats up above safe level, the power tool
will stop automatically to prevent damage to the Li-ion cells. The battery temperature is monitored by a
sensor. The power tool will work again when the battery temperature drops below 45°C.
Working instructions:
•
Always choose the correct type of drill bit or screwdriver bit for the worked material and screw.
•
For steel use perfectly sharpened bits made of high speed steel. These can be used for drilling into
plastic, too.
•
Avoid overheating of drill bits by letting them cool down during stops.
•
For wood use drill with a centering point. Small screws can be screwed into soft wood without the
need for pre-drilling.
•
When drilling large diameter holes, it is better to pre-drill the hole with a smaller diameter drill bit.
•
Smaller screws and bits in particular can be easily damaged if you adjust the appliance with too
high a torque and/or rotation speed.
•
For screwing/unscrewing use low rotation speed and matching screwdriver bits.
•
Keep the power tool as perpendicular as possible.
•
When working on materials with smooth surfaces, the power tool can easily slip. To prevent this,
you can, for example, make a small hole with a nail or puncher.
•
Do not apply to much power on the power tool during operation, as this will cause the device over
load. Overloading leads to reduce speed and working results.
CARE, MAINTENANCE AND STORAGE
Warning! Risk of injury! Before performing any operation remove the battery pack.
Warning: Other maintenance and repair work than those listed in this manual, must
only be performed by an authorized manufacturer's service. Safety and operational
reliability can only be guaranteed when using original spare parts.
The power tool is almost maintenance-free
•
Keep the power tool and the air vents clean and unplugged.
•
Make sure that no moisture reaches the inside of the power tool during cleaning.
Cleaning
•
Before cleaning and maintenance always switch the power tool off and remove the battery.
•
Wait until the power tool has come to complete stop.
•
Clean the power tool after every use.
•
Clean the power tool with a wet cloth. Do not use cleaning agents or solutions; these can corrode
the plastic parts of the power tool.
Storage
•
Keep the power tool in a dry and safe place. Remove the drill or tool from the chuck.
•
When storing a lithium-ion battery for extended periods, check the state of charge regularly. The
optimal "storage" charge level is approximately 50-80% - three green LEDs on the power indicator.
EN - 32
Publicidad
