MTF AV 0012EB Manual Del Usuario página 33

TROUBLESHOOTING
Problem
Drill does not work
Vibrations are too strong
Motor overheated
Charger does not work
Battery is not recharging
TECHNICAL DATA
Cordless drill driver MTF AV 0012EB
Rated voltage
No load speed 1.gear
No load speed 2.gear
Maximum torque
Chuck clamping range
Max. drilling diameter, wood / steel
Weight without battery
Weight with battery
Battery charger
Rated voltage
Charging voltage and current
Li-ion battery pack BT 15-12 EB
Nominal voltage
Capacity
Noise and vibration
The declared vibration level stated in the technical data and in the declaration of conformity has been
measured in accordance with the standard test method prescribed by the relevant standards and can be
used to compare individual tools with each other. The declared vibration level can also be used to
predetermine exposure.
Warning! Vibration value during actual use of the power tool can differ from the declared value
depending on the way the power tool is used. The vibration level may increase above the level stated.
When assessing vibration exposure to determine safety measures under Regulation 2002/44/EC to
protect persons regularly using power tools in employment, exposure to vibration should consider, the
actual conditions of use and the way the power tool is used, including taking into account all parts of the
operating cycle such as the times when the power tool is switched off and when it is running idle in
addition to the start time.
Sound pressure level L
Sound power level L
wA
Uncertainty K = 5 dB (A)
Possible cause
Empty battery
Battery overheated above
45°C
Drill or tool not mounted
correctly
Overload due to excessive
pressure to work
Mains socket is not live
Power cable fault
Temperature of battery is
outside of safe range 0-45°C
= 71,3 dB(A)
pA
= 82,3 dB(A)
Solution
Recharge the battery pack
Let the battery cool down
Check and mount the drill or tool correctly
Allow the motor to cool down by running
the power tool idle at maximum speed for
1 minute
Check mains socket and/or circuit
breaker/RCD
Check whether power cable is
disconnected or damaged
Let the battery reach normal temperature
before charging
12 V
0-400/min
0-1400/min
30 Nm (18+1 settings)
1-10 mm
22 mm / 8 mm
0,9 kgs
1,1 kgs
100–240 V, 50-60 Hz
13,5 V 0,4 A
12 V
1,5 Ah
Vibration level a = 1,698 m/s
hD
Uncertainty K = 1,5 m/s
EN - 33
2
2