Publicidad
Idiomas disponibles
Idiomas disponibles
The generator's engine is designed to run on unleaded 95
petrol. Never use contaminated fuel or an oil and fuel
mixture. Avoid dirt or water in the fuel tank.
To check the fuel level and fill the tank, the engine must be
stopped.
When refilling the fuel tank do not add petrol above
the maximum level, the upper limit of the filter.
▪ The generator's direct current is 12V;
▪ Start the engine first and only then connect the
generator to the battery;
▪ After you start charging the battery, make sure the DC
overload protector is on.
1. Start the engine;
2. Clamp the red cable to the positive pole (+);
3. Clamp the black cable to the negative pole (-);
4. Set the ESC switch to "OFF" position to start charging the
battery.
▪ Make sure the ESC switch is OFF positioned while the
battery is charging;
▪ Make sure you connect the cables to the correct
terminals. Never connect in reverse;
▪ Be sure to clamp the cables to the terminals firmly so
that they will not be disconnected by engine vibration or
other disturbances;
▪ The DC overload protector automatically turns off if the
current goes above normal values while the battery is
charging. To charge the battery again, switch on the DC
protector by pressing the button. If the DC protector
turns off again, disconnect the battery immediately and
consult the brand or your authorised dealer.
When using the generator, check that the total load is
within the normal output voltage of a generator. Otherwise,
damage may occur.
AC
Power
1
factor
Output
≤3.500W
rated power
It is possible to use AC and DC power simultaneously, but
the total power should not exceed the rated power.
Generator rated power
Frequency
Power factor
AC
DC
---------
Overload indictor light comes on when total power
exceeds power range.
▪ Do not overload. The total load of all electrical devices
must not exceed the power range of the generator.
Overloading will damage the generator;
▪ When supplying power to
electronic
controllers,
based equipment or battery chargers, keep the
generator at a sufficient distance to avoid electrical
interference from the engine. Also check that the
electrical noise from the engine does not interfere with
other electrical devices located near the generator;
▪ If the generator is going to supply medical equipment,
you should first get advice from the manufacturer,
doctor or hospital CEO;
▪ Some electric equipment or engines for general use have
high inrush currents and therefore cannot be used, even
if they are within the power range limits indicated in the
table above.
0.8-0.95
0.4-0.75
(Efficiency 0.85)
≤2.800W
≤1190W
3.200W
1.0
≤ 3.500W
100W (12V / 8.3A)
precision equipment,
computers,
microcomputer-
Publicidad
