Kohler K-T16229 Guia De Instalacion página 4

Ramp
Measure to finished
wall with stick or pen.
1. Determine the Wall Thickness
NOTE: The plaster guard must be in place for these steps.
NOTE: The finished wall must be installed before you perform these
steps.
NOTE: If the plaster guard is inside the finished wall, the wall is too
thick for the install and the valve needs to be moved forward.
NOTE: This trim is designed to allow for a 1-1/2" (3.8 cm) variation
in wall thickness.
Take a straight object such as a pencil and hold it along the
outside edge of the mud guard with the tip touching the finished
wall.
Either mark the spot where the top edge of the plaster guard and
the pencil meet or hold the pencil with your fingers at that spot.
Move the pencil to the inside of the plaster guard. Touch the tip
of the pencil to the bottom of the plaster guard at the deepest
point next to the area labeled "1."
1066047-2-C
Plaster Guard
Finished
Wall
0
Spacer
2
1
(Thin Wall)
Spacer
(Medium Wall)
4
Ramp
Max Finished Wall
Thickness
Spacers
(Thick Wall)
Kohler Co.