lowcostmobile MIMO Manual Tecnico página 7

English
4G LTE 5G Antenna Panel LTE MIMO LowcostMobile 2x10m black
cable ALSR200, SMA Connectors
We would like to inform you about the differences in "4G/5G networks bars" visible on the
router or from the administration interface with our mobile antenna and without an
antenna. In many cases without our antenna, you pick up a low frequency inside your home,
it's a frequency that has intrinsic properties of radio propagation ideal in the atmosphere
and that penetrates well through buildings. BUT, when you install our mobile antenna
outside or inside as high as possible, the operator station and router will always pick up the
highest available frequency deployed by the operator automatically, instead of the lowest
that has the most signal. The higher frequency is more difficult to penetrate in the
atmosphere and across buildings.
This phenomenon is observed because the operators manage their frequencies efficiently,
and thus you can pass substantially from 3 bars of networks in 4G 800Mhz (low band) to 0, 1
or 2 bars of networks in 4G 1800Mhz 2100Mhz or 2600Mhz (Intermediate and high), or 1 bar
of network 5G 3500Mhz without you being able to intervene because many routers do not
allow to block on a defined 4G/5G frequency. This is why you should not mix your
interpretations, your comparisons with or without antenna, if you do not know on which
frequency you were without antenna. A bar of 4G 1800Mhz can provide you with more
throughput than 4 bars of 4G 800Mhz, a bar of 5G 3500Mhz can provide you with more
throughput than 4 bars of 5G 700Mhz. The rates vary according to the frequency spectrum
allocated by each operator but also the rates available during your tests which vary
according to the number of users connected, operator network congestion, IP Range and
depending on the type of connection between the operator station and the Internet
network.
7/22