Installation and first use of Heat Wave Style 1000 / Heat Wave Style 1500 LCD
•
Please remove the device from the packaging and remove the protective foil.
Please mount the feet with the help of the enclosed screws.
•
• Please make sure that the housing, the power cord and the plug are not damaged.
• Please check that the specified mains voltage matches that of your mains supply.
• This device requires a voltage of 220-240V, 50/60 Hz and a current not higher than 15A. Only after
checking the voltage, the device can be connected to the power outlet.
Operation Heat Wave Style 1000
• The room temperature can be adjusted via the thermostat. Please turn the thermostat knob
clockwise to increase the heating power and anticlockwise to decrease the temperature until
you reach the desired temperature. The operating light will illuminate as you do so.
• The thermostat automatically maintains the set temperature.
• When the desired room temperature is reached, you can turn the control knob back to the
• position, where the unit will turn off.
Switch the heater to one of the following power levels.
(0) Off
(IV) 600W
(V) 1200W
(VI) 1800W
• The power light is on when the unit is activated.
• When you stop using the unit, please turn the power level control to "Off" (0), set the thermostat switch to low
(LOW) and unplug the power cord.
Remote Control Heat Wave Style 1500 LCD / 2000 LCD
ON/OFF
•
When the unit is off, pressing "ON/OFF" will start the unit at the medium heating level (Heat Wave Style 2000
LCD model starts on the low heat setting); when the unit is on, pressing "ON/OFF" will turn the unit off.
MODE
•
Arrangement of heating power setting for three positions: high → medium → low (For Heat Wave Style 2000
LCD high → low)
TIMER
Auto power off function: Increase or decrease the auto power off function of maximum 24 hours. Press the
•
"+" key to add one hour at a time and the "-" key to subtract 1 hour.
1
ON/OFF
2
Heating levels
3
Timer
4
Temperature
5
Up- button
6
Down- Button