Suntec Wellness KLIMATRONIC Heat Wave 1000 Style Manual Del Usuario página 18

Usage Heat Wave Style 2000 LCD
Please turn on the power switch on the side of the control panel.the heater indicator "
Power button to start the heater, the current ambient temperature and "L" are displayed on the control panel.
The number on the right side of the temperature symbol indicates the current ambient temperature. The number on
the right side of the timer symbol is "0". The heater goes into standby mode.
Heatingmode High/Low
• First press the button (ON/ Power/ OFF) to start the heater. In the meantime, the heater will enter the operation
mode and the low heating power icon (1000W) "L" and the
and the heater indicator "
operating.
• Press the (ON/ Power/OFF) button again to select the high heating power mode. The high heating power icon
(2000W) „H " and the heater indicator icon "
heating mode.
• If you press the (ON/Power/OFF) button a third time, the low heat icon, the high heat icon and the heat indicator
icon will be deactivated, which means that the heater is in the high heat mode.
which means that the heater goes into standby mode.
• By continuously pressing the (ON/ Power/ OFF) key, the heater can be cycled from the low heating level to the
high heating level and back again.
Timer
• Press the "MODE" button and the number on the right side of the timer icon "
• Then press the "+" or "-" key to select the time range (1 to 24 hours).
• When the number flashes five times, the remaining time for that timer will be displayed and the timer icon "
will light up.
Thermostat
• Press the "MODE" button again and the number on the right side of the temperature display icon "C°" will start
flashing.
• Then press the "+" button or the "-" button to select the temperature range (15℃ to 35℃).
• When the temperature range is selected and the number flashes five times, the heater will adjust to the desired
temperature and heat the room accordingly as needed.
Note: If the preset temperature is lower than the ambient temperature, the heater will not heat.
Switch off
• Press the key (ON/ Power/ OFF), the LED displays of the symbols "H", "L" and "
the timer symbol "
Cleaning
• Always disconnect the appliance from the mount before cleaning it! Make sure that is has cool down
completely!
• Clean the outside of the appliance with a damp and clean cloth und dry it with a dry cloth afterwards.
• Never use aggressive cleaning agents or chemicals, only use mild detergents.
• Never disassemble the appliance for cleaning.
• Never rinse or spray the appliance with water!
Troubleshooting
• If the appliance malfunctions, check the following points first:
• Check the connection to the mains outlet and make sure that the outlet is live (e.g. plug in a lamp and check if it
lights up),
• Check if the appliance is turned on
• Check if the appliance stands on a firm surface. Uneven or tilted positions can trigger a tilt safety switch. If that
is the case, adjust the position of the appliance accordingly.
" light up, indicating that the heater is in low heating mode.
" and the temperature symbol "°C" remain lit. The heater sets the heating mode.
" will light up, indicating that the heater is operating in the high
" light up. First press the
" will flash.
" are switched off. However,
"