Ivoclar Vivadent PrograPrint PR5 Guía Breve página 5

1.2. Documents of equal applicability and required files
For details on the documents of equal applicability, please contact your
local trade partner or go to the download section of Ivoclar at
www.ivoclar.com.
In the download section, you can find additional files, such as:
– DME file for the software "Dental System"
Document Explanation
Operating Instructions Comprehensive information on the use of
PrograPrint PR5 PrograPrint PR5
Instructions for Use for Information about the use of the materials to be
the different materials processed
Operating Instructions for Information about requirements that must be
the cleaning unit observed for the transport, set-up and use of
PrograPrint Clean PrograPrint Clean
Operating Instructions for Information about requirements that must be
the post-curing unit observed for the transport, set-up and use of
PrograPrint Cure PrograPrint Cure
Instructions for Use for Handbook for the PrograPrint CAM software
PrograPrint CAM
Short Instructions for: Excerpt of operation-relevant topics from
the respective Operating Instructions
– PrograPrint PR5
(this document)
– PrograPrint Clean
– PrograPrint Cure
2. Safety
WARNING! Improper use of the device.
Hazard to the user.
f The safety chapter contains important information on the safety of the
device: Please read it thoroughly prior to installation and operation.
The device is built according to state-of-the-art technology and recognized
safety regulations. Nevertheless, operation bears the risk of injury to the
user or third parties. Moreover, impairments of the device and other
property are possible.
2.1. Intended use
PrograPrint PR5 has been designed for 3D printing in dental technology.
Use the PrograPrint PR5 exclusively for this purpose.
In the case of damage caused by improper use or failure to observe the Operating
Instructions, all liability and guarantee claims are void.
Please note that only the materials and cleaning agents approved by the manufacturer
ensure processing without damage to the machine.
All information regarding material and indication extensions corresponds to
the state of knowledge at the time of going to print.
For additional details, go to http://www.ivoclar.com.
The Ivoclar Download Center is available at
https://downloadcenter.ivoclar.com/#lang=en
The use of non-approved materials from other manufacturers is not
recommended due to the lack of coordination with the printing/fabrication
process.
5