Publicidad
Idiomas disponibles
Idiomas disponibles
•
Press the auto-off button (n) and the display will show the previously set
auto-off time. If you want to change it, press the same button (n) again
and, just as with the time of switching on, set the automatic switch-off
time (0-24), bearing in mind that the switch-off time must not be earlier
than the switch-on time. NOTE: setting the same switch-on and switch-
off time will put the device into standby mode!
[Only in UNI_HEATER_10] Use the buttons for increasing and decreasing
•
the value of a given parameter (h or f) to set the target temperature.
Next, save it in the device's memory with the confirmation button (g).
•
Repeat the above steps if necessary for the remaining days to program
the entire working week, including individual days, on and off times.
[Only in UNI_HEATER_09] After programming the previous steps
•
according to the above, press the day selection button (j) to set the day
of the week to start the automatic operation. Then select the time of
switching on with the edit button (m). With the buttons for increasing
and decreasing the value of a parameter (h or f), select the target
temperature and save it in the device's memory with the confirmation
button (g).
•
Press the automatic operation programming button (k) to activate or
deactivate the automatic weekly program (the corresponding light on
the control panel will be on or off).
IMPORTANT: during automatic weekly operation according to the
programmed schedule, pressing the buttons (j, l, m, n) allows you to
check the time settings for a specific day and its set time interval
program.
If no specific heating temperature is set, its default value is 23
However, when the ambient temperature is higher than that set on the
device, it will not start up.
When the power is turned off, the automatic weekly program will be
lost.
3.3.8 "Open window" detection function
o
C.
Publicidad
