Publicidad
Idiomas disponibles
Idiomas disponibles
With this function ison, when the ambient temperature drops by 5-10
10 minutes, the device will turn off the heating and switch to standby mode.
To start the open window detection function, press the on/off button of this
function (i) on the panel of a turned-on, warmed-up device (it must work a bit
on heating). Then the appropriate indicator will light up to indicate its
activation:
By default, the target heating temperature is set to 23
desired value with the buttons for decreasing/increasing the value of the
parameter (f/h).
To deactivate the open window detection function, press the function button
on the remote control again. The function indicator on the control panel will
turn off.
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
Wait until the rotating parts stop.
•
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Do not spray the unit with a stream of water or immerse it in water.
d)
Make sure that no water enters through the ventilation openings in the casing.
e)
Clean the ventilation openings with a brush and compressed air.
f)
Use a soft, damp cloth for cleaning.
g)
Remove the battery from the appliance if you do not intend to use it for a long
time.
h)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
i)
Do not clean the device with acidic substances, medical products, thinners,
fuel, oil or other chemicals as this may damage the device.
j)
In case the device does not fully respond to the remote control, check the
condition of the battery and, if necessary, replace it with a new, functional one.
To replace the batteries of the remote control, press the latch of the battery
compartment (at the bottom of the remote control at its back) and pull out the
C within
o
C. To change it, set the
o
Publicidad
