Publicidad
Idiomas disponibles
Idiomas disponibles
Display Functions
Speed indication, power indication, error code indication,
lights control, cruise control, gear level switch and gear
indicator, total mileage, single mileage, real-time voltage,
running time, acceleration control.
Communication protocol: UART
Multi-indicator Area
Total mileage ODO, single mileage TRIP, real-time voltage V,
running time TIME, error code E.
Speed Indicator
Unit: MPH, km/h.
Speed signal comes from the motor via controller to the
display. The indicated speed depends on the motor signal
and the wheel diameter.
Gear Switch
Short press the MODE button to switch the gear, 1: slow,
2: medium and 3: fast. The higher the gear, the faster the
speed. Gear 0 means the motor is not powered.
Lights Control
Long press the MODE key to switch on/off the front and rear
lights. Rear lights are also lit automatically when braking.
Cruise Control Function
When riding the scooter, keep the acceleration handle
pressed with the same pressure for 5 seconds to activate
the cruise control mode. Use the brake handle to deactivate
the cruise control mode.
EN
18
Start mode selection
For safety purposes all Joyor models are set by default
to non-zero start mode which means the motor will not
get started until you start kick the scooter first so that the
speed is above zero:
NON: Non-zero start mode
ZERO: Zero start mode
USB Charging Indicator
The display is equipped with a USB port for you to be
able to charge your electronic devices. When the device
is connected, the USB indicator is lit. In case of problem
the indicator starts to flash, and a safety mode will be
automatically activated.
Parameter setting and definition
Long press the M and ON/OFF at the same time to enter
into the parameter settings mode. Short press the ON/OFF
button to switch between parameters. Short press M to
change the settings. Long press the M and ON/OFF at the
same time to save and exit.
P01: Screen brightness
1: the darkest and 3: the brightest.
P02: Mileage unit
0: km and 1: mile.
P04: Sleep mode time
0: sleep mode deactivated and 1-60: sleep mode (minutes).
EN
19
Publicidad
