Publicidad
Idiomas disponibles
Idiomas disponibles
P06: Wheel diameter
Unit: inch. Precision: 0.1.
P07: Number of measuring magnets
Range: 1-100.
P09: Start Model
0: zero start and 1: non-zero start.
P12: Starting torque
Range: 0-5. 0: the weakest and 5: strongest.
P15: Motor drive signal percentage settings
Full speed is set to 100.
P16: Cruise control function
1: activated and 0: deactivated.
P17: Light settings
The lights are not lit automatically when the vehicle is on, 0: the
lights are lit automatically when the vehicle is on.
P99: Setting reset
When in P99 settings, press and hold the M button for
5-6 seconds to reset all the parameters back to the initial
settings.
EN
20
Error Code Indicator
When the symbol ! is flashing, short press ON/OFF switch
button to enter into the error analysis mode. Each number of
the error code corresponds to a specific problem as follows:
Error
NO.
Definition
Code
1
ERRO 1
Motor failure
2
ERRO 2 Accelerator throttle failure
3
ERRO 3 Controller failure
4
ERRO 4 Brake failure
5
ERRO 5 Under voltage protection
Communication failure, the display cannot
6
ERRO 6
receive the output from the controller
Communication failure, the controller
7
ERRO 7
cannot receive the output from the display
EN
21
Publicidad
