2.3. Personal safety
a)
The device is not intended to be used by people (including children), who are
mentally, sensory or intellectually impaired or without adequate experience
and/or knowledge, unless they are supervised by a person responsible for their
safety or have been given instructions on how to operate the device.
b)
The device may be operated by physically fit, capable and properly trained
persons who have read this manual and have been instructed in occupational
health and safety.
c)
The device is not a toy. Children should be supervised to ensure that they do
not play with the device.
2.4. Safe use of the device
a)
Do not overload the device. Use tools suitable for the application. Correctly
selected device will perform better and safer work for which it was designed.
b)
Do not use the device if the ON/OFF switch does not work properly (it does not
turn on and off). Devices that cannot be controlled with the switch are
dangerous, must not work and must be repaired.
c)
Pull the plug out of the socket before making adjustments, changing
accessories or storing the device. This preventive measure reduces the risk of
accidental starting.
d)
When not in use the devices should be stored out of the reach of children and
people unfamiliar with the device or this instruction manual. The devices are
dangerous in the hands of inexperienced users.
e)
Keep the device in good technical condition. Before each work check for
general damage or damage related to moving parts (cracks in parts and
components or any other conditions that may affect the safe operation of the
device). If damaged, have the device repaired before use.
f)
The device should be kept out of the reach of children.
g)
Repair and maintenance of devices should be performed by qualified persons
using only original spare parts. This will ensure safe use.
h)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
i)
When transporting and moving the device from the place of storage to the
place of use, observe the health and safety regulations of manual transport
work applicable in the country where the devices are used.
j)
Avoid situations where the device stops under heavy load during operation.
This can cause the drive components to overheat and damage the device as a
result.
k)
Moving parts or accessories must not be touched, unless the device has been
disconnected from the power supply.
l)
It is forbidden to move, rearrange or rotate the device during operation.