b)
Use only non-corrosive products for surface cleaning.
c)
After each cleaning, all parts must be thoroughly dried before the device is
reused.
d)
Store the device in a cool and dry place, protected from moisture and direct
sunlight.
e)
It is forbidden to spray the device with a stream of water or immerse the device
in water.
f)
Regularly inspect the device for serviceability and any damage.
g)
Use a soft cloth for cleaning.
h)
Use a soft, damp cloth for cleaning.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as these may damage the surface of the device material.
DISPOSAL OF USED DEVICES.
At the end of its service life, this product must not be disposed of with normal
household waste but must be taken to a collection point for recycling of electrical
and electronic equipment. This is indicated by the symbol placed on the product,
operating instructions or packaging. The materials used in this device are recyclable
according to their labelling. You make an important contribution to protecting our
environment by reusing, recycling or otherwise disposing of used equipment.
Please contact your local authority for the appropriate disposal point.
TROUBLESHOOTING
The problem
No response
when pressing
▲ or ▼ buttons
after connecting
the power.
Low lifting speed
or slippage when
lowering.
The engine does
not work as
instructed.
Overloaded.
Insufficient
height when
Possible cause
No cable connection.
Desk overloaded -
maximum load 150 kg.
Engine problem.
Duty cycle exceeded:
maximum turn-on 2 min /
turn-off 18 min.
Change of factory settings.
Work
Make sure that all cables are
securely connected.
Ensure that the load on the
desk does not exceed 150
kg.
Contact the supplier or
retailer.
Restart after disconnecting
from power for 18 minutes.
Press and hold the M and 3
buttons at the same time for
at least three seconds until