Publicidad
Idiomas disponibles
Idiomas disponibles
XVII. A cable tray (3) should be installed in the middle of the beam joint when the
frame is elongated more than 1720 mm.
XVIII. The length of the cross beam should not exceed the limit opening position.
3.3. Working with the device
Height adjustment:
1. Connect the plug to the mains supply.
2. Use the buttons on the control panel to adjust the height.
CONTROL PANEL DESCRIPTION
The control panel has the following 7 buttons:
▲ : height adjustment up button
▼ : height adjustment down button
1 : button for the first user stored altitude position
2 : button for the second user stored altitude position
3 : button for the third user stored altitude position
M : altitude memory function button
A : button to set an alarm to remind the user to change position
Using control panel:
• Height adjustment function:
Use buttons ▲ or ▼ to adjust the height. The current altitude is shown on the
LED display.
• Altitude memory function:
a. By pressing buttons ▲ or ▼ you can get the desired height. Press the M
button to save the altitude in the memory - S will appear on the display. Then
press the button 1, 2 or 3 which will assign the altitude to the pressed button
and display accordingly S-1, S-2 or S-3.
b. Pressing the button 1, 2 or 3 will automatically adjust to the stored altitude.
• Reminder function:
LD - LED display
Publicidad
