Atlas Copco MT Focus 400 CHN Instrucciones Del Producto página 22

Troubleshooting
Troubleshooting
Troubleshooting
Controller reference
Controller messages
The controller can show the following messages on the status bar of the display:
Angle exceeded
Angle not reached
Batch OK
Bit slip detected
Cancel
Disable
Error in step n
Global time exceeded
Global time not reached
Hold angle exceeded
I/O
Max torque exceeded
OK
Step n
Seating angle exceeded
Seating torque exceeded
Service required
Time exceeded
Time not reached
Torque exceeded
22
EN
PSet has been selected from ToolsTalk
The defined Max. Angle for the step has been ex-
ceeded.
The defined Min. Angle for the step has not been
reached.
Batch completed.
The bit slips from the joint after the torque has
reached 70% of the target torque (if Bit slip detection
is set to On)..
Tightening cancelled.
System is disabled.
A process error in step n has occurred as described in
the following line.
The defined Max. process time for the entire tighten-
ing process has been exceeded.
The defined Min. process time for the entire tighten-
ing process has not been reached.
The hold angle exceeded the value specified in Max
hold angle.
PSet select source is set to IO.
Total step torque is greater than Max. allowed
torque.
Tightening completed successfully.
Tightening process step n active.
If Final tightening method is Angle:
Seating angle is exceeded by 5% or more.
If Final tightening method is Torque:
Seating angle exceeded Seating angle supervision.
Seating torque is greater than Max. torque (shown
only if Final tightening method is Torque).
Service reminder, the time since last calibration has
elapsed or the set number of tightenings since last cal-
ibration has been performed.
The defined Max. time for the step has been ex-
ceeded.
The defined Min. time for the step has not been
reached.
The defined Max. torque for the step has been ex-
ceeded.
© Atlas Copco Industrial Technique AB - 9836 791600 00
MT Focus 400