Femi Job Line TR 1030-DB Manual De Instrucciones página 47

THE ARM
During the use of the machine, the head must never be blocked in the lower position. The head can be blocked
in the lower position only for transportation or when it is not in function
To release the arm:
1. Push down gently the arm and keep it in this
position.
2. Pull and turn the knob (A) Fig.16.
3. Lift up the arm to the upper position.
To block the arm in the lower position:
1. Lower down the arm to the lower position.
2. Pull and turn the knob (A) Fig.16.
HANDS AND FEET POSITION
Your cut will be easier and safer if you adopt a
correct hands and body's working position. Stand
on the side of the machine, do not stand on the line of the chips ejection.

Keep a good and balanced position. Keep your hands at least 10cm away from the disk. Hold strongly the
work-piece against the guide and keep your hands in working position until the starter trigger has been
completely released and the disk has come to a complete stop

Before cutting:
A. Do a test-cut with the machine off, to determine the path of the disk,
or
B. Switch the laser on and check that the path of the disk with the laser ray track. See the USE AND SETTING OF
THE DOUBLE LASER SYSTEM in case it needs to be adjusted.
WARNING!
- Do not cross arms in the disk area while cutting.
Make sure that the base and the angles are blocked before cutting.
EN
45
Fig.16