Femi Job Line TR 1030-DB Manual De Instrucciones página 53

1. Lift up the head.
2. Lift the lower disk protection (A) Fig.19 with one hand while
with the other hand you unscrew the two screws (B)
blocking the disk protection plate (C) and connecting the
disk lower protection to the disk upper protection (D).
3. Pull the plate towards the table keeping the blade
protection on the lower, then lay everything on the table.
This will allow you to reach to the blade bolt Fig.21.
1. Push the blade's stop button (A) Fig.20, then hand-rotate
the disk until the shaft blocks.
2. Unscrew the shaft screw using the special key delivered
with (A) Fig.21.
Note : rotate the screw clockwise to unscrew and anti-clockwise
to screw.
1. Pull away the shaft washer (C) then take out the disk.
2. clean the flange before positioning the new disk. Only
mount 305mm disks. Verify that the disk's direction of
rotation (arrow on the disk) corresponds to the direction
indicated by the arrow on the disk's upper protection. Make
sure the disk is beyond the flange.
3. Put an oil drop on the internal and external washers.
4. Place the new disk on the shaft; make sure that the
internal washer is correctly mounted.
5. Reposition the external washer
6. Push the stop button of the disk, insert the disk's screw
and screw it up anti-clockwise, using the special key
delivered with.
7. Reposition the plate and the disk lower protection
described in point 2. insert and screw up the screws (B)
Fig.19.
WARNING!
flanges are designed for such thickness and can only grant the disk stability in such condition.
It is only allowed to use blades of the same thickness as the original blade;
EN
51
Fig.19
Fig.20
Fig.21