Femi Job Line TR 1030-DB Manual De Instrucciones página 54

REPLACEMENT AND REGULATION OF THE BELT
When the belt needs to be replaced or re-tensed,
proceed as follows:
1. Disconnect the feeder cable.
2. Push down the head, pull and rotate the blocking
knob (A) Fig.16, to maintain the mitre saw in
transport position.
3. Unscrew and remove the three screws (B). open
the belt cover (A) Fig.22.
4. To loosen the belt, open the six screws (A) Fig.23
inside the belt box and modify the position of the
motor. Then open the warm-screw (A) Fig.24 to
loosen the belt tension.
5. Remove the used belt.
6. Place the new belt, checking it is centred on the
two pulleys
7. screw up the warm-screw (A) Fig.24, setting the
belt's tension so that, when you press the belt in
the centre, a clearance of about 1,3 cm is left.
8. Once the belt is tensed, screw up the six screws
(A) Fig.23.
9. Reposition the belt cover. Insert and screw up the
three screws (A) Fig.22.
All the tools and accessories FEMI are made and checked by using the safest and most modern productive
methods. However, if a tool get damaged, it must be repaired by an authorised after sales centre.
You can call the phone number 0542/487611 or by sending a request to the e-mail address
infocom@femi.it
EN
TECHNICAL SERVICE
52
Fig.22
Fig.23
Fig.24