cecotec CONGA 999 VITAL Manual De Instrucciones página 21

ENGLISH
Scrubbing intensity function
Press the Scrubbing level button on the remote control to adjust the water intensity during the
scrubbing process. There are 3 water levels: High, Medium or Low.
Cleaning scheduling
This robot includes schedule settings in order for you to customize the cleaning cycles. The
robot can only be scheduled through the remote control.
Note
Make sure the remote control is close to the robot when setting the clock or scheduling
cleaning cycles.
Setting the remote control's time
- Press the clock button on the remote control. Digits will start flashing.
- Select the current day of the week by pressing the upwards and downwards buttons. Fig.
30
- Use the left and right buttons to set minutes and hour. Use upwards and downwards
buttons to change the digit while it flashes. Fig. 31
- Finally, press the power or the clock button. The robot will beep when the time settings
have been confirmed. Fig. 32
Setting cleaning schedule
- For a better and more comfortable cleaning, the robot includes a schedule function to set
daily schedules through the remote control or the App in those Conga models that include
app. In accordance to the configuration, the robot will automatically start cleaning the
selected days at the desired time.
- The time options on the remote control are: 12:00 a. m.–11:59 p.m. and 12:00 p.m.–11:59 p.m.
- Before setting the time and the robot configuration, make sure the robot's power switch is
on and that the power button on the robot is lit up.
Configuration with the remote control
Press the schedule button on the remote control. Digits will start flashing. Fig. 33
- Use direction buttons to select the day. Once selected, use right and left buttons to select
minutes and hours. Use direction buttons when digits are flashing to set the desired
minutes and hours. Press the power button to save settings. Enter the desired days and
follow the same steps to schedule them. Fig. 34
- Finally, press the schedule button to exit scheduling mode. The robot will beep once
indicating the scheduled cleaning settings have been confirmed.
- The user may schedule as many days per week as desired. The home screen will display
when the robot is scheduled.
40
Cancelling scheduled cleaning
Press the schedule button on the remote control, select the day you wish to delete and change
the set time to 00:00 am., this is the time to be set to cancel the cleaning programme. Fig. 35
4. CLEANING AND MAINTENANCE
- In order to lengthen your robot's shelf life and to allow your robot to operate at peak
performance, carry out the following procedures periodically.
- Empty the robot's dust tank.
- Press the dust tank's release button. Fig. 36
- Open the dust tank and empty it. Fig. 37
Robot filter cleaning
- Remove the filter.
- Carefully shake off all dust from the filter. 38
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
right side of the robot's bottom part.
Warning
Do not spray cleaning products directly on the sensor.
Main brush and silicone brush cleaning
1. Slightly press the main brush frame's tabs in order to open the main brush storage
compartment and to remove it. Fig. 39
2. Remove any hair, fluffs or dust collected in the brush and around the axes. Fig. 40
3. Clear and clean the robot's suction channel.
4. Reinstall the main brush and its frame. Fig. 41
High-efficiency filter
- The high-efficiency filter is designed with fibres that help trapping dust particles, dust
mites, pollen... It is very important to clean periodically the filter, to avoid these particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
- It is suggested to replace the filter by a new one after a maximum of 160 hours of use.
Recommendations
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
ENGLISH
41