Descargar Imprimir esta página

Halo PRIME 550 Guia Del Usuario página 24

Ocultar thumbs Ver también para PRIME 550:

Publicidad

Idiomas disponibles

Idiomas disponibles

TEMPERATURE PROBE
WHAT IS RTD TEMPERATURE PROBE?
The HALO Prime550 has an RTD (Resistance Temperature Detector) sensor probe inside the grill.
The probe is usually located on the left-hand side of the cooking chamber, where the hopper is
shielded with "C" bracket.
RTD-TEMPERATURE PROBE
Located inside the
smoke chamber,
on the left, is the
RTD-temperature
probe. It is a small,
vertical piece of
stainless steel.
The temperature
probe measures
the internal
temperature of
the unit. When
the temperature is adjusted on the Control
Board, the temperature probe will read the actual
temperature inside the unit and adjust to the
desired temperature.
IMPORTANT
The temperature of your unit is highly affected on ambient outdoor
weather, quality of pellets used, flavor of pellets, and the quantity of food
being cooked.
FIRST USE-PELLET GRILL BURN-OFF
Before using your pellet grill for the first time with food, it is important to complete a burn-off.
Start the pellet grill and operate it at the highest heat (350-375°F)/(176-191°C) with the lid closed
for 30 to 45 minutes to burn-off and get rid of any impurities.
24
24
MEAT PROBE
The meat probe
measures
the internal
temperature of
your meat in the
smoke chamber.
Plug-in the meat
probe adapter to
the meat probe connection port and insert the stainless-
steel meat probe into the thickest portion of your meat
and the temperature will be displayed on the control
board. To ensure the meat probe is connected properly to
the connection port, feel and hear it snap into place.
IMPORTANT
• When placing the meat probe into your meat, ensure the meat probe and
meat probe wires avoid direct contact with flame or excess heat. This can
result in damage to your meat probe. Run the excess wire out along the
edge of the front lid. When not in use, disconnect from the meat probe
connection port and place aside to keep it clean and protected.
• Make sure to place the protective cap in place to prevent any moisture
accumulation inside the jack receptacle.
Wired Meat Probe
Jack Receptacles

Publicidad

loading