Bruno SRE-2010 ELITE Manual De Instalación página 35

REPROGRAMMING REMOTE TRANSMITTERS (continued)
SRE-2010 INSTALLATION 02-08-2019
7. Press and hold LEARN/ERASE button
(LED on circuit board is on). As LEARN/
ERASE button is pressed down, press
either of the remote transmitter
buttons until LED goes out
(approximately 2-5 sec.).
8. Release both buttons. Remote is now
reprogrammed.
9. Test transmitter operation by
pressing either transmitter buttons.
  •Ifcarriagemoves,newconfiguration
has been accepted and transmitter
is reprogrammed.
• If carriage does not move, repeat
Steps 6 through 9.
10. Check that all transmitters are set to
same DIP switch configuration.
NOTE: It is only necessary to
reprogram one transmitter if
all transmitter DIP switches
are set the same.
11. Turn circuit breaker OFF.
12. Remount the control enclosure cover(s)
and the seat hinge plate cover.
13. Turn circuit breaker ON. Verify operation of
all functions.
35
© BRUNO INDEPENDENT LIVING AIDS, INC.®
ELECTRICAL