Franke NEPTUNE FHNE 604 3G TC Manual De Instalación Y Servicio página 11

INTENDED USE
CAUTION: This appliance is for cooking purposes
only. It must not be used for other purposes, for
example room heating.
Do not pull the appliance or the power cable to
Z
unplug it.
Close the general gas supply cock when the hob
Z
is not in use.
Risk of burns!
Do not touch the pot grids during use.
Z
Do not touch the appliance with wet parts of
Z
the body.
Lighting the burners
The hob is lit with the control knobs. To light the
burners, proceed as follows:
– Press and turn the required knob to the lighting
and max delivery position.
– Keep the knob pressed down for 3-4 seconds to
allow the sparks to ignite the gas coming out the
burner and to allow the thermocouple to heat up.
Then release the knob and, turning it anticlockwise,
adjust the flame as required. If the flame does not
stay lit, repeat the operation from step 1.
FHNE 604 3G TC, FHNE 755 4G TC, FHNE 805 4G TC,
FHNE 805 4G TC FM, FHNE COR4 3G TC
FHNE 1204 3G TC, FHNE 1204 3G TC FM
FHNE 604 3G TC / FHNE 755 4G TC / FHNE 805 4G TC / FHNE 805 4G TC FM /
FHNE 1204 3G TC / FHNE 1204 3G TC FM / FHNE COR4 3G TC
– 11 –
cock closed
lighting and max. delivery
min. delivery
dual total
dual inner
The hob is an item for daily use: signs of usage
such as scratches or visible material abrasion from
pots or cookware are normal. Intensive use leads
to more distinctive signs of usage. In such cases,
the appliance continues to function perfectly
and a complaint is not justified. Safety is always
guaranteed.
Do not use the appliance as support top.
Z
To avoid damaging the appliance:
In the case of thermal failure, switch the solid
Z
plate off and allow to cool down completely.
Do not put any dishes on it. Do not cool with cold
Z
water under any circumstances.
Do not climb onto the appliance.
Z
The appliance is manufactured in compliance with
the relevant effective safety standard an safety
requirements of Gas Directive.
Automatic Safety Valve
These hobs have a safety device that automatically
closes the gas flow if the flame accidentally goes
out due to draughts, pot spilling, or a temporary
interruption of the gas supply. This device is activated
approx. 30 seconds after the flame goes out.
Burner use
For lower gas consumption and better efficiency use
pots of widths suitable for the burners, making sure
the flame does not go beyond the edges (comply
with the following table):
EN