Franke NEPTUNE FHNE 604 3G TC Manual De Instalación Y Servicio página 9

* Flush fitting around top hole
H top = 3 mm
R = 11 mm (FHNE 805 4G TC FM)
R = 11,5 mm (FHNE 1204 3G TC FM)
Model FHNE COR 4 3G TC
Apply the sealing strip around the hole and position
X
the hob.
Fix the appliance with the screws and brackets.
X
Remove any excess sealing strip.
X
Connection to gas supply
Connect the appliance to the gas supply in
X
compliance with the current regulations, only
after making sure it is arranged for the type of gas
to be used. Otherwise, carry out the operations
described in the paragraph „Replacing injectors".
For liquid gas use pressure regulators complying
Z
with the current regulations.
FHNE 604 3G TC / FHNE 755 4G TC / FHNE 805 4G TC / FHNE 805 4G TC FM /
FHNE 1204 3G TC / FHNE 1204 3G TC FM / FHNE COR4 3G TC
– 9 –
Connection to the gas supply can be made in
two ways:
A. Connect the gas hob using a 12 mm diameter
rigid copper pipe (3). To ensure a good seal, use the
elastomer gasket supplied as an accessory (1).
B. Connect the hob using a continuous-surface
flexible steel tube (2). Also in this case, to ensure
a good seal use the gasket supplied as an
accessory (1). The maximum length of the hose is
2 linear metres.
Important: if a stainless steel hose is used,
it must be installed so as not to touch any mobile
part of the furniture. It must pass through an area
where there are no obstructions and where it is
possible to inspect it on all its length.
After connection to the gas supply light up the
X
burners and turn the knobs from max position to
minimum position to check flame stability.
After carrying out the connection use soapy water
X
to check for any leaks.
1
For United Kingdom, Northern Ireland and Republic
of Ireland.
1
Electrical connection
The FRANKE cooking hob comes with a 3-core
power cable with free terminals.
Ensure the following:
X
– The characteristics of your household electrical
power supply (voltage, maximum output and
current) are compatible with those of your
FRANKE hob.
1
2
3
2
3
EN