Nice MC824H Manual Del Usuario página 16

Output 3 (sca)
In this output the user can select one of the functions specified in Table 4.
FUNCTION
sca (= gate open indicator)
gate open
gate closed
maintenance indicator light
courtesy light
suction cup 1
red traffic light
green traffic light
radio channel no.1
TABLE 4: OUTPUT CONFIGURATION
DESCRIPTION
The programmed light indicates the operating status of the
control unit.
light off = application stationary in maximum Closing position;
slow flashing = application Opening manoeuvre execution
phase;
quick flashing = application Closing manoeuvre execution
phase;
light permanently on = application stationary in position oth-
er than maximum closing
Output active 24 Vdc / max 4 W
The programmed light indicates the operating status of the
control unit.
light on = application in maximum Opening position;
light off = application in other positions.
Output active 24 Vdc / max 10 W
The programmed light indicates the operating status of the
control unit.
light on = application in maximum Closing position;
light off = application in other positions
Output active 24 Vdc / max 10 W
The programmed light indicates the count of manoeuvres
completed and therefore the need (or not) for system mainte-
nance operations.
light on for 2 sec at start of Opening manoeuvre = number
of manoeuvres less than 80%;
light flashing during execution of entire manoeuvre = num-
ber of manoeuvres between 80 and 100%;
light always flashing = number of manoeuvres over 100%.
Output active 24 Vdc / max 4 W
This function type is ON/OFF. Important – For safety reasons,
as the light is not controlled by a timer, use of an adequate light
is recommended able to withstand the heat of the light emitted.
Output active 24 Vdc / max 4 W
With this function programmed, the suction cup is activated
when the application is in the maximum Closing position. Note
– The suction cup is disabled in all other situations.
Output active 24 Vdc / max 4 W
This function indicates activity of the application during the
phases of a Closing manoeuvre.
slow flashing = execution of Closing manoeuvre;
light permanently on = application in maximum Closing
position;
light off = application in other positions
Output active 24 Vdc / max 4 W
This function indicates activity of the application during the
phases of an Opening manoeuvre.
slow flashing = execution of Opening manoeuvre;
light permanently on = application in maximum Opening
position;
light off = application in other positions
Output active 24 Vdc / max 4 W
If this radio channel is set for the configuration of output 1
(flash), this channel is activated when a command is sent with
the transmitter. It is useful if installing external devices (for
example, an auxiliary light) in the same system to be controlled