TRAPP TRC-40 Manual De Instrucciones página 31

www.trapp.com.br
Ensure that there is oil in the crakcase and that it is at

the correct level.
Check whether there is fuel in the tank.

Only fill with good quality gasoline.

Open the fuel valve for the TRAPP / Lifan motor.

Position the choke valve (2) in the choke position

for the TRAPP/Lifan motor, as shown in figure 3.
Carefully pull the retractable start rope until you find

some resistance, then pull it all the way through.
Repeat this operation until the motor starts. Repeat
this operation until the motor starts.
Allow the engine to heat up for a few minutes, then

reset the choke to its original position.
Note:
This TRAPP/Lifan engine model has

fixed throttle.
9
10
Image merely illustrative
Figure 3
Operation - TRC-50


Notes:


11
To turn the TRAPP / Lifan motor off in an emergency
situation, turn off the power cut button (1) as shown
in figure 3.
To turn-off normally, close the fuel valve (3) and wait
for the gasoline to be fully consumed, then turn off
the power switch (1) as shown in figure 3.
The engine does not respond upon
being accelerated without a load
(work force). The rotation only
increases when the machine is made
to work (under no circumstances
should the pressure of the original
spring of the accelerator be altered).
This motor has a power cut-off system
to facilitate the engine turnoff, before
starting, make sure it is not started,
this prevents turning the motor on.
31