TRAPP TRC-40 Manual De Instrucciones página 32

Warning!
All maintenance and cleaning should be
made with the equipment switched off and
the spark plug wire disconnected.
The air filter shall be always clean for the engine
to work perfectly. Never work without the air
filter in the engine to avoid damages and loss of
warranty.
Blocking of the filter due to lack of cleaning
causes serious operating problems for the
engine, among them loss of power, and damage
to the cylinder, piston and piston rings.
First 5 hours
Change the oil (Trapp / Lifan motor)
O
Every hours or daily
8
Check the oil level (gas engine)
O
Clean the machine after use
O
Every hours
25 or annually
Check and clean the air filter (gasoline engine)
O
Lubricate the bearing (gas engine)
O
Change oil
O
Every hours
50 o annually
Check and clean the gas engine exhaust system
O
Annually (check with a TRAPP Service Technician)
Replace the oil filter (gas engine)
O
Replace the spark plug (gas engine)
O
Replace the fuel filter (gas engine)
O
Clean the air cooling system
O
Check and clean the carburetor (gas engine)
O
Check the belts and replace if necessary (gas engine)
O
Check the rubber cushions and replace if necessary
O
Check and replace the cutter assembly if necessary
O
Note: 1) In very dusty places or when particles brought by the air are present, clean more frequently.
32
Air Filter
Periodic Maintenance Plan
1)
Air filter - foam
Dip and tighten (do not twist) it in a solution of

neutral detergent water, removing all the dirt.
Dry it, rolling and pressing it in a dry cloth (do not

twist it).
Moisten the filter slightly with clean oil, always

pressing it to distribute the oil equally, removing the
excess.
Air filter - paper
Pass compressed air from inside to outside the filter

or knocking its base lightly against a flat surface.
www.trapp.com.br