TRAPP TRC-40 Manual De Instrucciones página 33

www.trapp.com.br
Problem Probable cause
Bushing of 1. Excess feeding. Due to this fact, the
themachine
2. Crushed coconut moisture or coconut
Low production
1. Insufficient feeding of the machine.
2. Low rotation of the cutting assembly.
Irregular cut of the
1. Improper
product
Difficulty in starting 1. Voltage drop in the electrical network.
the motor
2. Lack of fuel or poor quality fuel in the
3. Incorrect throttle lever position on the
Troubleshooting
motor does not manage to maintain
the rotation required and the product
accumulates inside the machine
(continuing with the use may burn out
the motor by overload).
in state of decomposition.
blade sharpening
assembly.
gas engine.
gas engine.
Solution
1. Disconnect the equipment and wait
for the motor to stop. Open the feeding
funnel and clean the product excess
inside the machine, close the feeding
funnel, activate the motor, wait for it
to attain the maximum rotation and
restart the work, controlling the power
supply of the machine, so as not to
demand more than the motor capacity
can handle.
2. Select the coconut before crushing
and control the feed in case of coconut
with high humidity or in state of
decomposition.
1. Control the feeding so that it is
continuous, but not in excess so as not
to cause bushing.
2. Check that the rotation is correct.
or 1. Sharpen the knives as indicated in item
Cutting blades maintenance (page 28)
and check the assembly sequence and
correct if necessary.
1. Check the conditions of the electrical
network (electrician).
2. Check for fuel in the tank and verify that
it is in good condition; check the gas
engine carburetor and clean the bad gas
before adding fuel. Make sure the fuel
valve is open and the engine has the
throttle lever in the choke position when
starting the 6.5 HP TRAPP / Lifan motor.
3. Check the throttle lever position on
the gas engine.
33