GET 2ND INJ. KIT Guia De Instalacion página 8

4. Connect the OEM fuel hoses, A and B to the three-way fitting
supplied in the kit. Fasten everything with the hose clamps supplied.
To OEM Injector
To the fuel pump
D. SECOND INJECTOR KIT INSTALLATION
1.
Seal the contact surface between the second GET
injector support bracket and the intake sleeve of the air
filter box, taking care not to obstruct the holes you made.
We suggest using Athena's one-component RTV silicone
sealant, Athesil (not supplied in the kit).
2.
Position the support
bracket of the second
GET injector as indicated
in point 7 of section C.
Fasten the bracket to
the sleeve of the air
filter box through the
two Ø4 mm / 0.15" holes
using the two M4x14
screws included in the
kit, the relative washers
and self-locking nuts
supplied in
and screwing
from inside the intake
manifold.
EN
A
50 mm / 1.96"
OEM
the kit,
them
Ø 4mm
0.15"
8
B
To GET 2nd Inj
100 mm / 3.93"
Ø 4mm
0.15"