Wayscral KICKWAY E1 Instrucciones De Uso página 62

To adjust the external pad (outside the wheel), simply modify the
•
tension of the brake cable in order to obtain a gap of 0.2 - 0.4
mm, at the caliper or at the brake lever.
Never spray oil or any lubricant on the disc or pads (when
•
servicing the chain or the derailleur, for example). If this happens,
remove the grease from the pads and disc, or change them.
Check the alignment of the pads by turning the wheel. Your
•
scooter is ready to ride.
Discs: your bicycle is fitted with disc brakes of 120 mm in
•
diameter.
A nut and lock nut system on the brake lever allows you to adjust
•
the cable tension and so the braking force which will vary over
time depending on the wear of the brake pads.
Brake pads are standard, replace them when your pad no
•
longer has a friction component.
Remember that new brake pads must be broken in. They are broken in
by riding for a few minutes and alternating between sudden stops and
light braking.
2. Changing the brake pads
Remove the wheel and remove the worn pads from the brake caliper.
Position the new pads in the caliper so that the braking surfaces come
into contact. Do not touch the braking surfaces. Insert the pads one after
the other into the brake caliper.
Then adjust the brakes as described in the previous paragraph.
C. How to use your KICKWAY E1
Step 1: check that the silicone cover is covering the charging
•
connector and that your product is not damaged.
Step 2: unfold the scooter as recommended in section "III.
•
Folding and unfolding the scooter" and press the On/Off button.
Enter the electronic lock code defined in the paragraph
"Electronic lock of the scooter".
62/269