tibelec 976060 Manual De Uso página 11

1. Connect the black probe to terminal COM and the red probe to terminal
VmAΩ
2. Set the function switch to the desired AC voltage rating
3. Connect the test plungers to the circuit and read the value displayed on
screen once it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal
VmAΩ
2. Set the function switch to the desired DC voltage rating
3. Connect the test plungers to the circuit and read the value displayed on
screen once it has stabilised. When measuring DC voltage, the display
shows the polarity of the red probe.
1. Connect the black probe to terminal COM and the red probe to terminal
VmAΩ for a maximum measurement of 200mA or at the 10A terminal
for a maximum measurement of 10A
2. Set the function switch to the desired DC current rating
3. Connect the test plungers to the circuit and read the value displayed on
screen once it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal
VmAΩ
2. Set the function switch to the desired resistance rating
3. Connect the test plungers to the circuit and read the value displayed on
screen once it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal VmAΩ
2. Set the function selector switch to position
3. Connect the test plungers to the diode:
(A) Test in the direct direction: connect the black plunger to the cathode and the red
plunger to the anode, measuring the voltage in the direction of a normal diode; the
screen will display 0.5 to 0.7V and the blocked direction will display "OL".
(B) Test in the opposite direction: connect the black plunger to the anode and the
red plunger to the cathode. The diode is good if the display shows "OL".
11